Quick Help

The knowledgebase is a categorized collection of answers to frequently asked questions (FAQ) and articles. You can read articles in this category or select a subcategory that you are interested in.



 Why can't I set a delay of less than 3 seconds in a Sequence?

Solution

When the WiFiLink broadcasts a radio message for any LightwaveRF products to respond to, it does so for ~2seconds.

If two messages were broadcast simultaneously then they would conflict and one or both are likely to fail.

We have a minimum of a 3 second delay between any steps in a sequence so that there are no radio conflicts and the commands execute successfully.

 
Was this article helpful? yes / no